8 channel SBUS to PWM to PPM signal converter

Small size 8 channel SBUS to PWM to PPM signal converter. This module uses a high performance 32 bit microcontroller to process SBUS, PPM or PWM signals and output them to SBUS, PPM or PWM. Thanks to the high performance of the STM 32bit microcontroller that is used in this module, the output signals are very clean and stable. Input signals are automatically identified, there’s no need to manually configure this module.

Multiple status light visually shows you what the status of the module is.

This module can convert input signals in the following ways:

• Input a SBUS signal and simultaneously output PWM and PPM signals.
• Input a PWM signal and simultaneously output PPM and SBUS signals.
• Input a PPM signal and simultaneously output PWM and SBUS signals.

Accepted input signals:
PPM (CPPM)
PWM (common receiver signal)
SBUS (including futaba-R7008SB series, FrSky, etc.)

Indicator light:
For every different signal type, there is a colored LED available.

SBUS = blue led
PPM = green led
PWM = red led

When there is no input signal detected, all three led indicator are on.
When an input signal is detected, the corresponding led indicator will be on. The signal leds of the two other signal types, that now act as outputs, will flash.

For example, when the module detects a SBUS input signal, the SBUS LED (Blue) will be on and the PWM led (red) and PPM led (green) will flash.

Channel description:
1-8 channels are PWM signal input or output channels
SBUS channel is the SBUS signal input or output channel
PPM channel is PPM signal input or output channel

Wiring instructions:
Connect one or more PWM signals as input to PWM 1-8 and the module will output a PPM signal on the PPM channel and will output a SBUS signal on the SBUS signal pad.
Connect a PPM signal to the PPM pad and the module will output a PWM signal on CH1-8 and will output a SBUS signal on the SBUS signal pad.
Connect a SBUS signal to the SBUS pad and the module will output a PWM signal on CH1-8 and will output a PPM signal on the PPM signal pad.nal.

Technical parameters:
Input voltage: 3.3-20V
Current: 15MA
Dimensions: 26*11MM
Weight (including all servo headers): 2.7 grams

Packing list:
1x SBUS to PWM to PPM conversion module
1x 4P*2.54MM*3 pin straight male header
1x 4P*2.54MM*3 pin 90 degrees male header
1x 3P*2.54MM*2 pin 90 degrees male header
1x 6P*2.54MM pin straight male header

Note: headers are not pre-soldered. If you want to use headers, you need to solder them yourself.