Matek Systems CRSF-PWM Converter with built-in current sensor – CRSF-PWM-C [DISCONTINUED]

Matek Systems CRSF-PWM Converter – CRSF-PWM-C

CRSF-PWM converter to convert a CRSF receiver signal to a maximum of 10x PWM outputs. This CRSF-PWM converter features a built-in current sensor that is capable of handling 90A continuous and 220A peak. Thanks to 2 UART ports, you can connect a GPS or Barometer to the board to give you additional telemetry options.

Depending on your external sensor choice, this gives you the following telemetry options: RxBt, Curr, Capa, Bat%, GPS, GSpd, Hdg, Alt, Sats

Compatible with any receiver that outputs CRSF, so you can use this converter with ExpressLRS recievers and TBS Crossfire receivers.

This board is great to combine with the ELRS-R24-D receiver from Matek.

Different parameters can be set on this module using the Matek Configurator.
Detailed information about setting up this module can be found at the website of matek: click here

Model: CRSF-PWM-C

Matek Systems CRSF-PWM Converter with built-in current sensor – CRSF-PWM-C

• Compatible with CRSF protocol receiver only
• Support any CRSF protocol receivers (including 433MHz, 868MHz, 915MHz, 2.4GHz)
• 10x PWM outputs
• PWM frequency configurable (50Hz default, 100,160,330, 400Hz)
• 2x UARTs (for Receiver and GPS)
• Telemetry ID: RxBt, Curr, Capa, Bat%, GPS, GSpd, Hdg, Alt, Sats
• 36V Max. battery voltage sense (1K:10K voltage divider built-in)
• Current sensor built-in (90A continuous /220A Peak), current scale = 150 by default
• Vbat and Current sensor scale configurable
• Failsafe value auto set
• Firmware upgradeable
• Rated voltage: 4~9V @5V pad, 0~36V @BAT+
• No 5V regulator built-in, Servos must be powered via 5V pad by external 5V source.
• 26mm x 26mm, 2.8g

Includes

• 1x MATEKSYS CRSF-PWM-C with biult-in current sensor en external telemetyr option
• Dupont 2.54 pins

Compatibility

• This CRSF to PWM converter can work with all recievers that utilize CRSF as output protocol.

Wiring & configuring

This is an example how you could wire this CRSF-PWM Converter with built-in current sensor . All peripherals are for illustrative purposes only and are not shipped when you buy this product.

Detailed information about setting up this module can be found at the website of matek: click here