Matek Systems ELRS R24-P PWM Receiver – ELRS R24-P (2.4GHz) [DISCONTINUED]

ExpressLRS PWM Receiver (2.4GHz) made by Mateksys with 5 PWM outputs. Model R24-P

Matek Systems ELRS R24-P ExpressLRS PWM Receiver –  (2.4GHz)

Receiver for ExpressLRS with 5x PWM outputs in a small form factor. This receiver weighs 2gram with antenna and is 25x13mm (L x W). The receiver uses the ESP8285 and SX1281 chips to operate and runs on a 2.4GHz frequency. Receiver can be easily flashed by using ExpressLRS flasher or wifi flasher.

Important information about binding and flashing

This Matek Systems ELRS R24-P ExpressLRS PWM Receiver –  (2.4GHz) is pre-flashed with ExpressLRS 2.0, but can be updated with any ExpressLRS firmware you like. This ELRS receiver doesn’t have a binding phrase and can be bind with traditional binding mode. We recommend, however, to always update the ExpressLRS receivers and transmitters to the latest version.

Detailed information about flashign this receiver can be found on the website of Mateksys: Matek Systems ELRS R24-P ExpressLRS PWM Receiver –  (2.4GHz)

Firmware information

• ExpressLRS targets: Matek_2400_RX_PWM or DIY_2400_RX_ESP8285_SX1280
• ExpressLRS wiki for PWM receiver: PWM Receivers
• Make sure Receiver and TX module both are running the same ExpressLRS version

Specifications of Matek Systems ELRS R24-P ExpressLRS PWM Receiver –  (2.4GHz)

• ESP8285, SX1280/1281
• Antenna connector: IPEX MHF 1
• 5x PWM outputs
• RF Frequency: 2.4GHz (2400~2480MHz)
• Telemetry power: 12dbm
• Receiver protocol: PWM or CRSF
• Input voltage: 4~9V DC @ “+” pad
• Power dissipation: 45mA(binding), 85mA(wifi mode)
• PCB size: 25mm x 13mm
• Weight: 2g w/ antenna

Includes

• 1x MATEKSYS ELRS-R24-P
• 1x IPEX MHF1 Antennas. 15cm
• 1x Dupont 2.54 pins