FrSky RX6R 6/16 Channels Receiver (PWM/SBUS)
Small but very advanced FrSky RX6R 2.4GHz receiver that works with FrSky transmitters and with any multi-module transmitters like those from RadioMaster.
- High sensitivity (40% Increase of the range compared to previous X series receivers)
- Higher precision PWM (Less than 0.5uS deviation)
- Lower latency PWM (9ms in high speed mode, 18 ms in normal speed mode)
- Lower power consumption
- Supports redundancy function
- Smart Port enabled and supports telemetry data transmission
- Battery voltage detection
- 2 detachable IPEX 4 connector antennas
Read all information and capabilities of this receiver in the user manual: https://www.frsky-rc.com/wp-content/uploads/Downloads/Manual/RX6R/RX6R%20ACCST-Manual.pdf
Looking for Telemetry sensors?
Add SmartPort Telemetry sensors to your reciever, and show telemetry values on your transmitter.
How to use them with a Multi-Module transmitter
Receiver can be flashed by the user to a preferred firmware, but is supplied out of the factory with ACCST EU LBT firmware.
Firmware can be downloaded at https://www.frsky-rc.com/rx6r/
To work with a Multi-Module based transmitter, flash any preferred ACCST version to the RX6R.
Specifications of the FrSky RX6R
- Dimension: 21.1×17×7.3mm (L×W×H)
- Weight: 2.5g / 2.9g (with two antennas)
- Number of Channels: 16CH (1-6CH PWM from conventional channel outputs, 1-16CH from SBUS OUT port)
- Operating Voltage Range: 3.5V-10V
- Operating Current: 100mA@5V
- Operating Range: >2km
- Servo Frame Rate: 9ms (HS—High Speed Mode)/18ms (FS—Normal Speed Mode)
Reviews
There are no reviews yet.