Matek Systems ExpressLRS PWM Receiver – ELRS R24-P6 (2.4GHz)

ExpressLRS PWM Receiver (2.4GHz) made by Mateksys with 6 PWM outputs. Model R24-P6

Matek Systems ExpressLRS PWM Receiver – ELRS R24-P6 (2.4GHz)

This ELRS receiver features 6x PWM outputs in a very compact and lightweight form factor. The R24-P6 is only 2grams with antenna and the dimensions are 20mm x 18mm. This ExpressLRS PWM receiver works on 2.4GHz and must be feeded with 4-9V DC at the + pad. Built-in is also a voltage sensing option that can be fed with a maximum of 34V, make sure that you only connect this to the VBat pad! The ELRS receiver gots an IPEX MHF 1 antenna connector.

Important information about binding and flashing

This receiver is pre-flashed with ExpressLRS 3.0, but can be updated with any ExpressLRS firmware you like. The default binding phrase is ” 123456″ and the receiver will never enter binding mode if using the traditional binding procedure. To adjust the binding phrase reflash the receiver or go into the WebUI to set it to your own binding phrase.

Detailed information about flashign this receiver can be found on the website of Mateksys: ExpressLRS 2.4GHz PWm Receiver, R24-P6

Firmware information

• ExpressLRS targets: DIY 2.4GHZ or DIY 2400 RX PWMP EX
• ExpressLRS wiki for PWM receiver: PWM Receivers
• Make sure Receiver and TX module both are running ExpressLRS 3.0 or newer

Specifications

• 6x PWM outputs
• RF Frequency: 2.4GHz (2400~2480MHz)
• Receiver output protocol: PWM
• Input voltage: 4~9V DC @ “+” pad
• Voltage sense: 34V Max. @ “VBat” pad
• PCB size: 20mm x 18mm
• Weight: 2g w/ antenna
• Chips used: ESP8285, SX1281
• Antenna connector: IPEX MHF 1
• Support 2~8S VBat voltage sense
• Telemetry power: 12dbm
• Power dissipation:  45mA(binding), 85mA(wifi mode)

Includes

• 1x MATEKSYS ExpressLRS 2.4GHz Receiver – PWM ELRS-R24-P6
• 1x IPEX MHF1 Antennas. 15cm
• 1x Dupont 2.54 pins